Taxi Driver Online
http://www.taxi-driver.co.uk/phpBB2/

e7 rear facing flip seats
http://www.taxi-driver.co.uk/phpBB2/viewtopic.php?f=8&t=29303
Page 1 of 1

Author:  amccarroll30 [ Tue Jun 07, 2016 10:51 am ]
Post subject:  e7 rear facing flip seats

Hi

Got an e7 on 10 plate. Having problem with the 3 rear facing flip seats. When sitting on them they slope downwards, so passengers feel like they are sliding off them.

Have ordered new seat spring from Cabdirect and fitted them bit they still do the same thing.

Anyone have any ideas what's happening with them? Is there supposed to be stoppers of some sort on the seats which stops them going past 90 degrees?

Thanks

Author:  perry [ Tue Jun 07, 2016 8:31 pm ]
Post subject:  Re: e7 rear facing flip seats

They're all the same mate I had to take my seats out and weld a spacers in between the stops that's the only way

Author:  perry [ Tue Jun 07, 2016 8:51 pm ]
Post subject:  Re: e7 rear facing flip seats

If you do go down that route. Only add a thin peace at a time till you get the right angle. It's not that hard to do. I haven't had a complaint since. Before people always moaned on long runs that the seats were terrible. Bad design next time I will weld in a small bolt so I can wined it out to adjust it as it wares

Author:  wannabeeahack [ Sun Jul 17, 2016 12:31 pm ]
Post subject:  Re: e7 rear facing flip seats

Not a great idea, my Tourneo had great seating....

Comfy comfy comfy


Image

Author:  perry [ Tue Aug 02, 2016 7:57 am ]
Post subject:  Re: e7 rear facing flip seats

He didn't ask if YOUR transit seats are comfy
He asked how do you fix E7 flip down seats

Author:  wannabeeahack [ Thu Aug 04, 2016 8:29 pm ]
Post subject:  Re: e7 rear facing flip seats

perry wrote:
He didn't ask if YOUR transit seats are comfy
He asked how do you fix E7 flip down seats


easy

torch em

Author:  Dav_S [ Mon Jul 30, 2018 9:21 pm ]
Post subject:  Re: e7 rear facing flip seats

Anyone else got any advice on how to resolve this problem? I've also thought about drilling a hole for a bolt on the bottom plate next to the spring, with a nut either side. The bolt could then be adjusted to alter the stopping position. Problem is I'm not sure if the plate is strong enough at that point and may end up bending.

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/