Taxi Driver Online
http://www.taxi-driver.co.uk/phpBB2/

TX2 Timing chain slip
http://www.taxi-driver.co.uk/phpBB2/viewtopic.php?f=9&t=17925
Page 1 of 1

Author:  jam55king [ Thu Nov 24, 2011 11:52 am ]
Post subject:  TX2 Timing chain slip

Hi Just Taxis are telling me my timing chain has slipped and cracked the head, also need rockers etc £2500 does this sound right to you guys?? Thanks in advance

Author:  diesel [ Thu Nov 24, 2011 5:15 pm ]
Post subject:  Re: TX2 Timing chain slip

quite common, pre-tensioner failure sheet engine

Author:  blackpool [ Thu Nov 24, 2011 7:27 pm ]
Post subject:  Re: TX2 Timing chain slip

Are you allowed to put a nissan engine in ?Would be a better option

Author:  BTR [ Wed Nov 30, 2011 12:22 am ]
Post subject:  Re: TX2 Timing chain slip

Replacing the engine with a nissan 2.7 td engine out of a tx1 is a good choice but if you are going to get it done make sure you get it done properly i have seen some proper bodged up conversions cut and welded propshafts ,rear child locks don't work and the wiring is a right mess.
I had my cab done cost me £2400 but the lad who done it gutted a tx1 and put everthing into my 54 reg tx2 and everything is like it should be and works like it should if you decide to go down that route pm me and i will pass you on the number and he has engines for a tx2 which i am sure he will fit for you with a warranty less than the price you have been quoted.

Author:  Eiji [ Wed Nov 30, 2011 12:44 am ]
Post subject:  Re: TX2 Timing chain slip

Are there any downsides to putting a TX1 engine into a TX2?

Author:  BTR [ Wed Nov 30, 2011 1:27 am ]
Post subject:  Re: TX2 Timing chain slip

No mate i had the conversion done 2 years ago and it has been trouble free since i had it done but you have to be careful as some councils won't allow conversions.

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/