| Taxi Driver Online http://www.taxi-driver.co.uk/phpBB2/ |
|
| Fairway taxi bottom ball joints. http://www.taxi-driver.co.uk/phpBB2/viewtopic.php?f=9&t=22602 |
Page 1 of 1 |
| Author: | Baconsdozen [ Wed Jul 03, 2013 8:43 pm ] |
| Post subject: | Fairway taxi bottom ball joints. |
A puzzler. I took my fairway in for an MOT and it failed on a bottom ball joint. The tester showed me and it had a 1/2 inch of up and down play. I was sure when I looked at it a few days ago it was fine but-no doubt about it the thing was bouncing up and down so badly I half thought of taking it home on a trailer. It was an absolute swine to get the tapered pivot out of the bottom arm.The nut had been done up so tight that I had to use a 3/4 drive breaker bar.I broke my splitter,jacking it up on the stub and the old two hammer trick didn't work. In the end loads of heat,a jack under the stub with the weight of the car on it and a ten foot scaffold pole and jemmy made it part,it sounded like a clap of thunder when it finally moved.The two bolts holding the joint to the upright were tight as hell and rounded off,all in all the job took three hours. I have the old swivel in front of me.There is no play at all and it moves and rotates smoothly no matter how hard I try to compress or stretch it there is no play,it doesn't even look worn. Any ideas,or am I going ga ga ?. |
|
| Author: | blackpool [ Wed Jul 03, 2013 9:25 pm ] |
| Post subject: | Re: Fairway taxi bottom ball joints. |
Sometimes it is hard to tell when its off vehicle,did you not notice a improvement with new one on ? |
|
| Author: | Baconsdozen [ Thu Jul 04, 2013 10:43 am ] |
| Post subject: | Re: Fairway taxi bottom ball joints. |
I'll be fitting the new one later on today. I'll let you know. |
|
| Author: | blackpool [ Thu Jul 04, 2013 10:55 am ] |
| Post subject: | Re: Fairway taxi bottom ball joints. |
They can be a fecker to get off,the bigger the hammer the better !!! |
|
| Author: | Baconsdozen [ Thu Jul 04, 2013 7:15 pm ] |
| Post subject: | Re: Fairway taxi bottom ball joints. |
Got the new one fitted (much easier than getting the old one off). The steering might be a bit better but maybe that's wishfull thinking. Seems odd that the joints cost under a tenner yet one for my P5b rover which looks sort of similar is about ten times that. |
|
| Author: | blackpool [ Thu Jul 04, 2013 8:31 pm ] |
| Post subject: | Re: Fairway taxi bottom ball joints. |
Thats good ,they are cheap enough on parts which is a bonus,make sure you track it before you start scrubbing tyres |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|