upnorth2016 wrote:
Yes I have found it.
I have sprayed it with penetrating spray and moved it back and forth but even when I leave it in the On position (on t he tap) there still isn't hot air.
I am guessing the bit inside is not turning ie its seized inside.
Thought I would take it off and trying leaving it to sit in lubricating spray but I cannot get it off the pipes.
A couple of questions:
If I can get it off will water run out? Not sure how to stop that as the pipe is too thick for me to clamp it with anything I think.
If I can get the tap off the pipe how would I get the new one on? Are they normally pushed on by hand or someone sort of tool?
I don't know If the tx1 had a tap in the engine bay to begin with but what tap is on yours in the bay? Does it look like a stop cock? Most I've seen on tx1 on rank is just a random on off tap from the plumbers pipes cut and jubilee each side onto the barb. On mine which is a tx2 I just joined the pipes together and bypassed the matrix all together. I'll put it back if it was ever to get very cold this winter but with the windows shut it's warm enough down to low Temps